Web of Science: 4 cites, Scopus: 3 cites, Google Scholar: cites,
Preparation of nanocomposites of poly("-caprolactone) and multi-walled carbon nanotubes by ultrasound micro-molding. influence of nanotubes on melting and crystallization
Olmo, Cristian (Universitat Politècnica de Catalunya)
Amestoy, Hegoi (Universidad del País Vasco)
Casas, Maria Teresa (Universitat Politècnica de Catalunya)
Martínez, Juan Carlos (ALBA Laboratori de Llum de Sincrotró)
Franco García, Lourdes (Universitat Politècnica de Catalunya)
Sarasua, José Ramón (Universidad del País Vasco)
Puiggalí, Jordi (Universitat Politècnica de Catalunya)

Data: 2017
Resum: Ultrasound micro-molding technology was successfully applied to prepare nanocomposites based on a poly(ε-caprolactone) (PCL) matrix and multi-walled carbon nanotubes (MWCNTs). Optimization of processing parameters (i. e. , amplitude, force and time) was crucial to obtain nanocomposites without any evidence of degradation, high material saving and short processing time (7-8 s). Good dispersion of nanotubes was achieved after processing previously formed solvent casting films. This dispersion was even partially detected in pieces directly obtained from powder mixtures of both components. Incorporation of MWCNTs had a remarkable influence on melting and crystallization processes, which were systematically studied by time resolved synchrotron experiments. Results indicated higher melting and crystallization temperatures for the nanocomposite, with temperature differences higher than 5 °C. Carbon nanotubes were effective nucleating agents and had an influence on crystallinity, crystallization rate and even on lamellar morphology, which was evaluated by analysis of the correlation function of small angle diffraction profiles. Crystallinity within lamellar stacks was lower for the solvent casting nanocomposite, but in this case lamellae underwent a thickening process during heating that accounted for the increase in the melting temperature. Crystallization from the melt rendered similar lamellar morphologies at the end of the process due to a lamellar insertion mechanism.
Nota: Número d'acord de subvenció MINECO/MAT2015-69547-R
Nota: Número d'acord de subvenció MINECO/MAT2015-69367-R
Nota: Número d'acord de subvenció AGAUR/2014/SGR-188
Drets: Aquest document està subjecte a una llicència d'ús Creative Commons. Es permet la reproducció total o parcial, la distribució, la comunicació pública de l'obra i la creació d'obres derivades, fins i tot amb finalitats comercials, sempre i quan es reconegui l'autoria de l'obra original. Creative Commons
Llengua: Anglès.
Document: article ; recerca ; publishedVersion
Matèria: Carbon nanotubes ; Crystallization ; Micro-molding technology ; Morphological parameters ; Nanocomposites ; Synchrotron radiation ; Ultrasounds
Publicat a: Polymers, Vol. 9, Issue 8 (August 2017) , art. 322, ISSN 2073-4360

DOI: 10.3390/polym9080322
PMID: 30970997


18 p, 6.2 MB

El registre apareix a les col·leccions:
Articles > Articles de recerca
Articles > Articles publicats

 Registre creat el 2019-02-19, darrera modificació el 2019-06-11



   Favorit i Compartir