First-principles study of isomorphic ('Dual-Defect') substitution in kaolinite
He, Man-Chao (China University of Mining and Technology. State Key Laboratory for Geomechanics and Deep Underground Engineering)
Zhao, Jian (China University of Mining and Technology. State Key Laboratory for Geomechanics and Deep Underground Engineering)
Fang, Zhi-Jie (China University of Mining and Technology. State Key Laboratory for Geomechanics and Deep Underground Engineering)
Zhang, Ping (Institute of Applied Physics and Computational Mathematics)

Data:	2011
Resum:	Kaolinite is often a cause of deformation in soft-rock tunnel engineering, leading to safety problems. In order to gain a better predictive understanding of the governing principles associated with this phenomenon, the physical and chemical properties of kaolinite were investigated using an efficient, first principles scheme for studying isomorphic substitution of Al ions in kaolinite by two kinds of other elements (namely, the dual defect). Elements that are relatively common in natural kaolinite were chosen from groups II (Be, Mg, Ca, and Sr) and III (Fe and Sc) of the Periodic Table as dual-defect ions to substitute for Al ions in kaolinite. By systematically calculating the impurity-formation energies (which characterize the difference in the total crystal energy before and after the defect arises) and transitionenergy levels, which characterize the energy cost for the transformation between two different charge states, the (Be + Sc) (i. e. the replacement of two specific Al ions in kaolinite by external Be and Sc ions), (Ca + Sc) , (Mg + Sc) , and (Sr + Sc) ion pairs were determined to have low formation energies, suggesting that these combinations of ions can easily substitute for Al ions in kaolinite. The (Be + Fe) , (Ca + Fe) , (Mg + Fe) , and (Sr + Fe) ion pairs have relatively high formation energies which make isomorphic substitution (or doping) in kaolinite difficult. Moreover, these combinations of elements from groups II and III were found to have relatively low transition-energy levels compared with other element pairs. Among them, (Sr + Sc) have the lowest transition-energy level at 0. 06 eV above the valence band maximum. When compared with single external substitutional defects in kaolinite, remarkably, the dual defects have relatively low formation energies and transition-energy levels. The results are helpful in understanding the chemical and physical properties of natural kaolinite.
Drets:	Tots els drets reservats.
Llengua:	Anglès
Document:	Article ; recerca ; Versió publicada
Matèria:	First-principles Calculations ; Engineering of Clays ; Formation Energy ; Kaolinite ; Point ; Defect ; Transition-energy Level
Publicat a:	Clays and Clay Minerals, Vol. 59, Núm. 5 (2011) , p. 501-506, ISSN 1552-8367

DOI: 10.1346/CCMN.2011.0590507

6 p, 737.6 KB  Accés restringit a la UAB

El registre apareix a les col·leccions:
Articles > Articles de recerca
Articles > Articles publicats