visitant ::
identificació
|
|||||||||||||||
Cerca | Lliura | Ajuda | Servei de Biblioteques | Sobre el DDD | Català English Español |
Pàgina inicial > Articles > Articles publicats > Antimicrobial and wear performance of Cu-Zr-Al metallic glass composites |
Data: | 2017 |
Resum: | The antimicrobial and wear behaviour of metallic glass composites corresponding to the Cu50+x(Zr44Al6)50-x system with x=(0, 3 and 6) has been studied. The three compositions consist of crystalline phases embedded in an amorphous matrix and they exhibit crystallinity increase with increasing copper content, i. e. , decrease of the glass-forming ability. The wear resistance also increases with the addition of copper as indirectly assessed from H/Er and H3/Er2 parameters obtained from nanoindentation tests. These results are in agreement with scratch tests since for the alloy with highest Cu content, i. e. , Cu56Zr38. 7Al5. 3, reveals a crack increase, lower pile-up, prone adhesion wear in dry sliding and higher scratch groove volume to pile-up volume. Samples with higher Cu content revealed higher hydrophilicity. Time-kill studies revealed higher reduction in colony-forming units for E. coli (gram-negative) and B. subtilis (gram-positive) after 60 min of contact time for the Cu56Zr38. 7Al5. 3 alloy and all the samples achieved a complete elimination of bacteria in 250 min. |
Ajuts: | Ministerio de Economía y Competitividad MAT2014-57960-C3-1-R Agència de Gestió d'Ajuts Universitaris i de Recerca 2014/SGR-1015 |
Drets: | Aquest document està subjecte a una llicència d'ús Creative Commons. Es permet la reproducció total o parcial, la distribució, i la comunicació pública de l'obra, sempre que no sigui amb finalitats comercials, i sempre que es reconegui l'autoria de l'obra original. No es permet la creació d'obres derivades. |
Llengua: | Anglès |
Document: | Article ; recerca ; Versió acceptada per publicar |
Matèria: | Tribological properties ; Antimicrobial behaviour ; Metallic glass composite ; Scratch test ; Nanoindentation |
Publicat a: | Materials & design, Vol. 115 (Febrer 2017) , p. 93-102, ISSN 0261-3069 |
Post-print 20 p, 1.4 MB |